Hi fellas, does anyone know the best way to add a zx9r loom to a loom from a pinto.
Brad

I would always use the whole bike loom its pretty straight forward brad

your car loom will have an ignition live and a cranking live. You can either use the full bike loom and just wire these two in, or strip the loom down to the basics. Best if you spend a while understanding the bike loom so you can remove or modify as required. Do you have a copy of the zx9 loom diagram?

[Edited on 31/3/07 by JoelP]

I do have a Haynes manual on zx9, it should be in there, but i tend to get a bit lost on wiring diagrams.

have you got the switch gear from the bike

Brad are you going to the humber bridge meeting tomorow ?
sorry of topic

No to the switch gear, and yes to the Humber Bridge meet.

its well worth your effort spending a few hours tracing thought the diagrams.

Cheers Mark, that's roughly what i thought was best to do, just need to swat up now on the bike loom.
Brad