Alrite chaps,

For people that have gone down the megajolt route, bit of direction needed please.

Where can I get the megajolt bits and board from for a TPS megajolt set up? I see the unit selling as complete for circa £100 but surely theres suppliers that sell as a kit to be soldered? £100 seems a bit pricey to me.

Ta very much!

Nath

£100 is a bargain and worth every penny.

Omex , Alpa , Dunnell ect ect

You wont see change out of £450

You can build it cheaper if you make 10 as some bits have a min order quantity. Get one ready made and tested. There are a couple of guys around here that could sort you out

Imho

try paulf or ray ward

With exchanges rates working io our favour, you can buy direct from USA

Autosport Labs

Allow about another £20 - £25 if you are unfortunate to be hit for import duty.

You should be able to do it for a lot less especially if you can aquire the coil pack, crank sensor, EDIS4 and TPS cheaply. I used a Zetec 1.8 in my last 2 Westfields and only needed an EDIS4 as the rest was with the engine.

The PCB and components was about £30 plus delivery from Bill Shurvinton from the WSCC forum but that was a few years ago. Not sure if he still does them.
A case was under a tenner from Maplin.

Pretty sure Bill Shurvinton still does them, he's certainly still doing Megasquirts etc. Stick his name in google and you'll find his email.

ta very much for the help, im looking into it.

Nath

This any good??

http://www.turbosport.co.uk/showthread.php?t=120120