dewbries
|
| posted on 24/3/09 at 09:10 PM |
|
|
TPS Pin identification
Hi there all,
I am just changing from Webers to zx9r carbs, got them back form Boggs with manifold and fired up the motor. However I need to connect the zx9r TPS up
and need to identify which wire goes to which pin. Can any body help.
Cheers
Second build. Now refining and changing drive train
|
|
|
|
|
omega0684
|
| posted on 24/3/09 at 09:47 PM |
|
|
is the tps a 5v one, the wire on the left is normally the power feed, the centre wire is the signal wire and the right hand wire is the earth.
|
|
|
will121
|
| posted on 24/3/09 at 09:51 PM |
|
|
this method worked for me
link to previous post
|
|
|
dewbries
|
| posted on 24/3/09 at 10:04 PM |
|
|
Not sure what voltage the tps is but the one on the webers was a 5v. The one on the zx9r carbs is original to the carbs. Thanks for help chaps.
Second build. Now refining and changing drive train
|
|
|
dewbries
|
| posted on 24/3/09 at 10:12 PM |
|
|
Thanks I have followed the links and think I can work it out now. Should be ready to take it over to Boggs. Cheers
Second build. Now refining and changing drive train
|
|
|
