roadrunner
|
| posted on 31/3/07 at 06:57 PM |
|
|
cec to bec wiring
Hi fellas, does anyone know the best way to add a zx9r loom to a loom from a pinto.
Brad
|
|
|
|
|
zxrlocost
|
| posted on 31/3/07 at 07:08 PM |
|
|
I would always use the whole bike loom its pretty straight forward brad
|
PLEASE NOTE: This user is a trader who has not signed up for the LocostBuilders registration scheme. If this post is advertising a commercial product or service, please report it by clicking here.
|
JoelP
|
| posted on 31/3/07 at 07:15 PM |
|
|
your car loom will have an ignition live and a cranking live. You can either use the full bike loom and just wire these two in, or strip the loom down
to the basics. Best if you spend a while understanding the bike loom so you can remove or modify as required. Do you have a copy of the zx9 loom
diagram?
[Edited on 31/3/07 by JoelP]
|
|
|
roadrunner
|
| posted on 31/3/07 at 07:30 PM |
|
|
I do have a Haynes manual on zx9, it should be in there, but i tend to get a bit lost on wiring diagrams.
|
|
|
zxrlocost
|
| posted on 31/3/07 at 07:40 PM |
|
|
have you got the switch gear from the bike
|
PLEASE NOTE: This user is a trader who has not signed up for the LocostBuilders registration scheme. If this post is advertising a commercial product or service, please report it by clicking here.
|
jacko
|
| posted on 31/3/07 at 07:43 PM |
|
|
Brad are you going to the humber bridge meeting tomorow ?
sorry of topic
|
|
|
roadrunner
|
| posted on 31/3/07 at 07:46 PM |
|
|
No to the switch gear, and yes to the Humber Bridge meet.
|
|
|
JoelP
|
| posted on 31/3/07 at 09:33 PM |
|
|
its well worth your effort spending a few hours tracing thought the diagrams.
|
|
|
roadrunner
|
| posted on 31/3/07 at 10:28 PM |
|
|
Cheers Mark, that's roughly what i thought was best to do, just need to swat up now on the bike loom.
Brad
|
|
|
