i got my clubsport a couple of years ago and it had to be a manual so waited out for one to come by eventualy found a really good one only problem was it had a small dent in the passesnger side door so had the intention of getting it sprayed but other than that the car was to stay standard but it didnt take long for the modding bug to bit again


last 5 are the nitrous ones

http://i297.photobucket.com/albums/mm238/autosri/P1000250.jpg

http://i297.photobucket.com/albums/mm238/autosri/P1000249.jpg

http://i297.photobucket.com/albums/mm238/autosri/P1000248.jpg

http://i297.photobucket.com/albums/mm238/autosri/637a7b1a.jpg

http://i297.photobucket.com/albums/mm238/autosri/94f00aa3.jpg

http://i297.photobucket.com/albums/mm238/autosri/90d2860c.jpg

http://i297.photobucket.com/albums/mm238/autosri/036ef3f6.jpg

http://i297.photobucket.com/albums/mm238/autosri/P1000274.jpg

http://i297.photobucket.com/albums/mm238/autosri/P1000279.jpg

http://i297.photobucket.com/albums/mm238/autosri/P1000280.jpg

http://i297.photobucket.com/albums/mm238/autosri/P1000275.jpg
heres how it looks now



here is the list of mods i can think of

STYLING

custom one off carbon/kevlar dash and door trims
custom gauge sender block for oil temperature and pressure
stuart warner gauges
custom gauge panel
diy autofad angel eyes
translucent blue headlight bowls
front number plate delete
plastidipped cs splitters
6k hid kit to replace oem
tri stitch alcantara gaitors
painted engine cover
plastidipped blue CS wheel lips
15mm spacers
blue calipers
roller rear arches
golf tee mod
dubmeister pressed plate
replace whole passenger side door because of dent
depo smoked indis
red dash needles
black vinyl roof wrap
tinter rearlights
black kidneys
LED angel eyes
10k hid fog lights

PERFORMANCE

powerflex fcab
powerflex rcab
custom cold air intake with filter in bumper
CDV delete
ebc yellow stuff front pads
ebc red stuff rear pads
dimpled and grooved disks
dot 5.1 brake fluid
jom coilovers
camber plates with spherical
alloy strut brace
stud conversion with tuner nuts
AEM wideband AFR gauge
resonator delete
oem 545 short shifter
alpina b3s rear roll bar
hyundai drop links
3.38 diff conversion
oem fire extinguisher under seat
clutch stop
shift limiter sounder
sierra cosworth spark plugs
custom 4 wheel alignment
ss braided brake lines all round

NITROUS/METHANOL

sb150i kit
direct port conversion
max extreme v1 race progressive controller
twin 5lb nitrous bottles
twin bottle heaters automatic controlled
purge valve
carbon vinyl wrapped bottles
aquamist 0.3mm meth nozzle
twin methanol pumps
1.2 litre 50/50 meth/water bottle

AUDIO

sound deadened rear shelf
sound deadended front doors and cards
jl audio XR 2 way comps
phoenix gold ax402x fully active crossover
alpine mrv f 340
alpine mrd m350
2 way diss block
audio control EQL ballanced differential /graphic equalizer
twisted pair rca cables
twin 6 inch infinate baffle subs on rear shelf

i think thats about it but sure i missed loads

hope you like

[Edited on 2/4/12 by Autosri]

[Edited on 2/4/12 by Autosri]

[Edited on 2/4/12 by Autosri]

i canny see the picture

having technical problems i just loaded them on another forum and worked fine tried again here and it wont work trying again now

not my cup of tea. too boy racerish. so long as your chuffed though.

I think that looks pretty good and reasonably understated, just enough mods to personalise it without going over the top - well done.

Meth and water? Didn't realise that would work

Cheers for the comments guys I appreciate it's not gunna be everyone's taste i mainly put them up you you lot to see the nitrous as I thought it may have been of interest

Yeah I run a mix of 50/50 methanol and de ironised water it only sprays when on nitrous and works as race gas and slows the burn speed down as its not easy to take the ignition timing out on mine that's required for the 125 shot of nitrous