Few bits for sale.

Brand new and never used danST ford pinto bike carb conversion.

1x TIG welded danST Engineering Aluminium inlet Manifold

1x Set of 37mm Keihin or Mikuni Carburettors ZZR660

1x danST Engineering Carb Fitting Kit (4x Fluoro lined silicone hoses and 8x stainless mikalor clamps) in red, blue or black

1 x danST Heavy Duty 1mm Thick Novus Inlet Gasket

It has been sitting in the garage for a couple of years so the carbs might need a look at. Cost over ｣400 new so looking for ｣200 but open to offers.


1.8 pinto engine, not complete. It been taken apart cleaned and had all new bearings and piston rings and also has a shortened sump. Not sure if it runs as i never checked it. Open to offers on this one but I need it gone within a couple of weeks.

4-2-1 complete pinto exhaust and silencer ｣150

I'm in Steyning west sussex but can deliver/post items at extra cost.

Pictures in photo archive.

[Edited on 25/1/18 by Harquil1908]

Have you sold the car Jim?

Im interested, I have got 2 sets of Pinto bike carbs that for different reasons don稚 work on my Pinto.
I am away for the weekend, when I get back if still available will get in touch.

Sounds good.

I知 back, what carbs are on the manifold? I have a dodgy set of Mikunies and have set up the throttle and choke for but that痴 no real obstacle just interested?

This is the link to what I bough from danst. I can稚 tell you what make the carbs are though I知 afraid. Does it say somewhere on them?

https://danstengineering.co.uk/index.php?route=product/product&path=59_94_176&product_id=259

It値l say on the carb body side.
Not to worried, I値l buy them.
I知 off to the pub, u2u and I値l arrange payment when I知 sober tomorrow.