finally got the chance to catch up with a few small jobs....
started by cutting some plates that go between the type 9 gearbox and pinto....template courtesy of daddylonglegs
then finished off a pinto intake manifold to take some bike carbs
then cut a flange for a turbo
then tack welded my remote gearshift....
also sorted my steering column wiring and tack welded the exhaust up.....
roll on tommorow!!!!
[Edited on 2/2/10 by boggle]
wow good work!
only thing is, your plate for the gearbox to engine is the wrong way round 
haha....
was gonna use the paper one!!!
Bloody 'ell!
I'm impressed mate, all the faffing for the template was worth it then. Good job 
will get it in the post for you tommorow.....u2u me your address.....
i have spare one up for grabs if this fits dll's box.....
quote:
Originally posted by boggle
will get it in the post for you tommorow.....u2u me your address.....
i have spare one up for grabs if this fits dll's box.....
Quality. Is the gear remote from the info i sent over? The flange looks good too.
Quality work bud. With all these templates, you could start a business!!
will send you the flange tommorow mate...i waterjet this one so you will see the difference in cut.....imho its better than laser
yes the remote is from your drawings....off to do a bit of turning thursday eve so it should be done by the end of the week........
was thinking of starting an ebay shop???
quote:
Originally posted by boggle
will send you the flange tommorow mate...i waterjet this one so you will see the difference in cut.....imho its better than laser
yes the remote is from your drawings....off to do a bit of turning thursday eve so it should be done by the end of the week........
was thinking of starting an ebay shop???
eBAy shop gets my vote too mate
Nice work. This is what I love about this forum 