Hi guys,

I need a bracket for my blacktop to mount a pulley at the top right of the engine where people normally do so that we can use the standard water pump.
Any ideas where I can buy one from?

I know the answer will be to make one myself but don't have a welder etc and my last one wasn't the best...


Cheers
Andy

Burton used to do them, not cheap iirc though....

If you mean for mounting alternator pulley. I should have one in the workshop. I dont have the pulley though. I can get the pulley number. I'll check first and let you know.

Similar to the raceline one
http://www.raceline.co.uk/products/part_section.asp?SectionID=60&CategoryID=4

[Edited on 3/4/17 by femster87]

that would be great, thanks!

You don't need a welder but a grinder would be handy. I cut mine out of a piece of 6 mm plate, drilled holes in the correct place and mounted a spare adjuster pulley. This ensures the pump will run in the correct direction.....

Got any photos of where you mounted it?

Not handy but I can go to the car tomorrow...

Nice one, much appreciated!