Board logo

2 wheeled dyno Vid
franky - 10/9/09 at 08:51 PM

Speakers with good LF response needed!

http://www.youtube.com/watch?v=0z6QtV2xSOs

On the lookout for the same engine to put in a locost

or maybe two!

big_wasa - 10/9/09 at 09:06 PM

so what was the power ? any ideas

omega0684 - 10/9/09 at 09:12 PM

what a cool job!

franky - 10/9/09 at 09:13 PM

137bhp at the wheel... 8500rpm
85lb/ft torque between 4-9000rpm

MikeRJ - 10/9/09 at 10:13 PM

Why would you go up through the gears at full power on a dyno?

afj - 11/9/09 at 07:32 AM

quote:
Originally posted by MikeRJ
Why would you go up through the gears at full power on a dyno?


im guessing at that point in the vid he was just fine tuning the map with an attempt at some 'real world riding' to see what the A/F ratio was doing

nick205 - 11/9/09 at 09:11 AM

Is that a standard service they offer at Vauxhall MasterFit centres then...?

franky - 11/9/09 at 09:19 AM

Saves me paying him for snap-on ones!

Full gear run as bike engines give best power on all gear runs as most modern bikes do not give full power on single gear runs. Also it shows that the A/F ratio is spot on in all gear under extreme usage.