I've got a heater mounted high on a stud partition which we want to move lower down the wall.
At present the heater is wired into a switched outlet (ie. not plugged in).and I would like to run a new cable from this outlet down to something
similar at the bottom of the wall.
Since it's a stud partition it would be helpful if I could run the cable down the cavity but how do you do this. I've seen it done by
electricians but never taken enough notice.
John.
isn't it done using that product that woman demo'd on Dragon's Den and had them all fighting for her to go into business with her?
I hope I am understanding you correctly but I have drilled holes at source and destination and fed a weighted string down from the top and caught it
at the bottom by using magnets/hooks.
Once you have a string you can tie off the cable and thread it through.
I have even heard of people threading cable under floor boards using rats/ferrits
[Edited on 9/5/10 by liam.mccaffrey]
It's not that tricky though if you have to go sideways or go down through any noggins it will mean cutting a square of plasterboard off, notching the noggin, feeding the cable through then putting the plasterboard back and making good.
Old metal coathanger sparkys normally use these
http://www.screwfix.com/search.do;jsessionid=BVUFPEEAQBJJYCSTHZOSFFY?_dyncharset=UTF-8&fh_search=Cable+rods&searchbutton.x=9&searchbutton.
y=10&searchbutton=submit
[Edited on 9/5/10 by adam1985]
Use a bit of mini trunking to fish through. Flexible enough to move around, stiff enough to go where you point it.
Sparks use it for this job.
quote:
Originally posted by zilspeed
Use a bit of mini trunking to fish through. Flexible enough to move around, stiff enough to go where you point it.
Sparks use it for this job.
quote:
Originally posted by mads
isn't it done using that product that woman demo'd on Dragon's Den and had them all fighting for her to go into business with her?
hi i just a set off
these or a scrap bit off cable.
stuart
Ferret.
i use a stiff bit of cable. You can use it to find the rough height of noggins, then use a 1 or 2mm drill bit to find it exactly, (ie drill in and you
will feel air or wood), these holes can easily be filled. Then drill as small a hole above and below as you can get the cable threaded through, and a
small channel over the stud/noggin.
If you fail, just drill as few additional holes as possible.
quote:
Originally posted by prawnabie
quote:
Originally posted by mads
isn't it done using that product that woman demo'd on Dragon's Den and had them all fighting for her to go into business with her?
Magnamole?