I have just been made redundent as a design engineer working for micron exhausts, where i did 3d cad design with Delcam Powershape.

I am going for an interview with a company that uses unigraphics CAD software, does anyone have any experiance with this software? how does it compare with Delcam Powershape or ProEngineer? is there a pirate copy out there i could get hold of to se how to use it?


cheers

Duncan

FlakMonkey is the man to ask. He has probably used/knows of it. I'm a ProDesktop user so can't help you. Best of luck with the job though

thanks

p.s. if anyone is in need of a (junior) design engineer in the midlands area then give me a call

Is Gavin still at Micron? Design Engineer too IIRC

there was no gavin working there when i was there, howvever i was only there for 18months so he may have moved on before i got there