Liam
|
| posted on 7/5/10 at 12:04 PM |
|
|
EMERGENCY - where to get 2" plastic tube end caps??
Hello knowledgable ones - here's a challenge for you...
Taking a test rig to Denmark next week, and due to an unfortunate tape-measure fault we just had to cut a couple of inches off the legs to fit in our
hired tranny van  . Would be awesome to get some of those caps/plugs that you can use to tidy up cut tube ends. 4 required for 50mm box section.
Where on earth do you get them from though?? Anybody in bedford area got any kicking around. Need them by Sunday morning latest.
Cheers
Liam
|
|
|
|
|
iank
|
| posted on 7/5/10 at 12:12 PM |
|
|
Like these?
http://cgi.ebay.co.uk/10-x-Plastic-End-Caps-Round-Tube-2-50mm-od-/270434657354?cmd=ViewItem&pt=UK_BOI_Metalworking_Milling_Welding_Metalworking_Su
pplies_ET&hash=item3ef729644a#ht_1688wt_941
Don't know if they could get them to you that quickly though.
Sorry re-read but they do them for box section as well.
http://cgi.ebay.co.uk/10-x-Plastic-End-Caps-Square-Tube-2-50mm-od-/270434665498?cmd=ViewItem&pt=UK_BOI_Metalworking_Milling_Welding_Metalworking_S
upplies_ET&hash=item3ef729841a#ht_1688wt_941
[Edited on 7/5/10 by iank]
--
Never argue with an idiot. They drag you down to their level, then beat you with experience.
Anonymous
|
|
|
02GF74
|
| posted on 7/5/10 at 12:38 PM |
|
|
short
or
long
other
they have trade counter in several places and do postage but it is minimaum quantity type stuff, around £ 15.
|
|
|
02GF74
|
| posted on 7/5/10 at 12:40 PM |
|
|
locations all ooop north
|
|
|
Liam
|
| posted on 7/5/10 at 12:54 PM |
|
|
Hmmm either of those sort of things would be good - square of course though. No time for ebay or post I dont think. Drawing blanks from local
suppliers and even fabricators on industrial estates etc etc. Oh well we'll just have to try hard not to scratch the floor of carlsberg brewery
|
|
|
vinny1275
|
| posted on 7/5/10 at 01:00 PM |
|
|
I've bought some of those from B & Q before - ours is a big warehouse one, they were in the section where they keep the steel box section
|
|
|
Liam
|
| posted on 7/5/10 at 01:30 PM |
|
|
Got some sorted from a local fabricators - pick up later today. Cheers for the help guys
|
|
|
