Board logo

Engine's in !!
dogwood - 8/11/08 at 05:53 PM

I wasn't going to post today
But I had such a good day thought I would post a pic now the engine's in.



Things are coming along nicely, Getting a little worried though coz the Wiring is Looming on the horizon....... Wiring....Looming....get it???

Can you guys have a look at this.
Tell me if there is a clip or something for this. I know, I know, I should check the manual, but I left it in England my last trip





David

001Ben - 8/11/08 at 06:09 PM

looking good. there should be a rubber mounting that pushes into the clip on the end of the throttle cable

[Edited on 8/11/08 by 001Ben]

speedyxjs - 8/11/08 at 06:48 PM

MakeEverything - 8/11/08 at 06:58 PM

Use a peice of small rubber hose to stop the clip coming off the shaft.

Looking good.

adithorp - 8/11/08 at 07:12 PM

Looking good. There should be a little rectangular rubber with a hole in the centre to go on the pin. It has a slight groove around the outside to locate the cable end.

"...Wiring....Looming....get it??? "

I'm sure at the current rate of progress a bright spark like you will sort it out.

adrian

dogwood - 8/11/08 at 07:44 PM

quote:

I'm sure at the current rate of progress a bright spark like you will sort it out.

adrian


Doh !!!

adithorp - 8/11/08 at 08:17 PM

Sorry... but you started it.

adrian