Does anyone know how to clean the progression jets (holes) of a weber DCOE without removing the carb from its place? I remember that the del'lorto carbs had a screw on cap which when removed exposed the progresion holes. If someone could also post a photo it would be appreciated, thanks

I should have one somewhere.. will try and dig it out.

Top of carb

http://www.locostbuilders.co.uk/photos.php?action=showphoto&photo=6pic1.jpg

Drillings uncovered

http://www.locostbuilders.co.uk/photos.php?action=showphoto&photo=4pic2.jpg

view from inside carb (note that aux vent and idle jet has been removed so yours will look different but you can atleast see where they come into the barrel)

http://www.locostbuilders.co.uk/photos.php?action=showphoto&photo=pic3.jpg

Thanks, but looks just slightly different to my carb. I'll get a photo up tomorrow. I will PM, thanks again.