Evenin all

Could someone tell me if the PX600 is supposed to come with the 3 sprung metal fittings that go on the backplate. I have finished cutting a blank backplate for one today and the pack of fittings i have with the filter only have the thumb mechanisms and plastic retaining washers!!

Cheers
Paul

The filter wont have the parts for the back-plate , and as far as I'm aware Pipercross wont sell you them either
But I do have some at work - they are a standard Dzues fastener - I can send you some ?

Typical Pipercross!!!

That would be fantastic if you could Claire - i'll drop you a U2U shortly.

Thats twice now the generosity of the forum members has bailed me (and the fellow member who's car it is!!) out in a couple of weeks. Big thanks to both yourself Claire, as well as Warren (Big_Wasa) who sent me a Mikuni TPS for fitting tomorrow.

Cheers
Paul

i recently rang pipercross as i had the clips for the back plate but had missplaced the screws over the winter. i may have been lucky but they sent me 3 new ones.

I tried to buy some a few years ago (I was doing a nice line in carbon back plates and airbox's at the time) and they just didnt want to know
But then I did want 50 .................