Hi People

I will be helping a mate this weekend start his Sierra dohc 2.0 motor .
Because I got my 1.8 injected motor going I thought it will be no problem to get a Sierra motor going.

It is a twin can carberetted motor .I have been thinking about what I need to wire up to get it to run.

So far I can Think of power to the coil , fuel and starter motor
What else do I need to wire up ???

From what I have seen of the loom there is a black box with alot of wire going to it , on it is "motorgard" , from what I see it is attached to the motor sensors , but not the ignition system.

Any help would be welcome.

Cheers

Vaughan

[Edited on 22/4/09 by vorn]

There is an ignition black box, which also takes a vacuum feed from the carburettor. I was going to use a DOHC Sierra motor, but went Zetec, on my home PC I may have the circuit diagrams for connecting the box, I did quite a bit of research before scrapping the idea.

Hi Pete

Any info would be great .

Cheers

Vaughan

[Edited on 22/4/09 by vorn]