do these fit the pinto block,or dose it need boring out???
thanks
jamie

[Edited on 4/5/09 by jpindy3]
i have found some,thay would be good for my turbo build,

[Edited on 4/5/09 by jpindy3]

From what i remember if its a 205 block you should be fine,

You will need to bore out the engine to fit them, I think, but the 205 block will take the bore.

Cossies run the same bore sizes as its the same block

You just need to know if they are over size. i.e. for a re-bore.
You would be best off with .5mm oversize. Then you can have the block bored/honed to fit the pistons.
There are loads of second hand standard pistons because they can not be fitted to a worn bore block.