i got my dellortos off a lotus turbo today,one of them is clean already.i have gone at it with a wire brush then a drimal i carnt get in all the tight bits,is there some kind of inside and out carb cleaner?
i was thinking of doing what alex did with his pinto parts,electrolais or somthing,
i dont know if that might be no good for them,
any ideas
thanks

yep, carb cleaner

wynns i think make it. works very well

Dunno about quickest but you'd be hard pressed to get them any cleaner than using this method

Cellulose thinners for taking gum off
Vinegar or Phosphoric acid or boric for corrosoion

[Edited on 28/5/09 by britishtrident]

quote:

---

Originally posted by UncleFista
Dunno about quickest but you'd be hard pressed to get them any cleaner than using this method

---

By far the best method

DO NOT USE THINNERS! BE WARNED!!

I used thinners to clean mine and they ended up in the bin. Had to buy another set.

It destroyed the rubber thats bonded inside for the needle jets and also stripped ali off the insides of the passageways. They were ruined.

Carb cleaner or soda blaster are the safest IMO.