hi there,i was checking the valve clearances and i took the plugs out so its not as hard to turn over,and i noticed a high pitch skweek coming from cly 4 as im turning it over,
anyone had this should i worrie??

oh its a pinto


the only thing i can think it is is a ring thats broke

[Edited on 9/6/09 by jpindy3]

anyone

I have had this on a pinto before,
it turned out to be the ring squeeking
as the the piston came up the bore.
It was nowt to worry about.
Do a compression test to check if you are worried,
that will tell you if you have a problem.
I did this recently and found non existent
compression on no 2 cylinder, i had to rebuild it.

Andy

Sounds a bit like high pressure bleed, past rings, or simmilar. I pressume that it occured as you got to maximum resistance to turning over.

Beaten to it but nowt to worry about.

thanks andy,your right its when it coming up the bore,i was gona cheack the cr tomorrow ,

thanks jamie