I have just brought a new front sprocket for the engine i picked up about a week ago.

The sprocket is loose when I tighten the bolt up, moves a millimetre or so - i am assuming there should be no play.

When i put the sprocket onto the spindle you can still see the spindle, if you get what i mean, unsure if there is something i am missing either side of it.

Many thanks

Probably missing a locking tab washer thingymajig

My sprocket adaptor was loose too. Fitted two lock washers and that sorted it.

They look like this:-



And you sort of bend them back around the nut.

HTH

Mike

eznfrank/Mike - Many thanks - just need to try and find one now.

No problem.

I got mine from the local Kwak dealer, were only a few quid and cheaper than the internet, by the time I had added the dreaded P&P!

Mike