Can anybody recommend me a fabricator in the North East for exhaust and inlet manifolds please,

I currently have home made manifolds for my 2.0l zetec on bike carbs and they need doing properly as they are restricting the flow quite a bit.

After this is there much improvement to be made by adding fast road cams to the engine.

Thanks...Andy

AAS in Scotswood did my exhaust.

http://www.aas-exhausts.co.uk/

Not sure if they do inlet manifolds. Failing that Bogg Bros in Malton aren't a million miles away?

http://www.boggbros.co.uk/contact.html

Mike

As above I have a super exhaust from AAS.

With a home made inlet for bike carbs which are big enough I had the carbs set up at Bogg Brothers. I'll be going down again to get them set up since I changed from 1.8 to 2.0 and will be asking about a cam change.

I understand your homemade exhaust may be restrictive but the inlet?

I can pop down and show you mine if you want?

Steve

[Edited on 29/6/09 by coozer]