are there 2 different size waterpump pully's on a pinto

i have ordered 2 off ebay so far and neither fits.

its the centre hole and mounting bolts are too small.

and doesnt seem deep enough

cheers gavin

[Edited on 17/7/09 by gavin174]

[Edited on 17/7/09 by gavin174]

What aspect doesn't fit?

I had two additional pumps aquired from random sources and all 3 were compatible.

What's the cause with yours?

Got any pics?

Cheers,
James

it depends on if they are for a car with a viscous fan or viscous & power steering or neather
Pump types: Linky

I've got a new pump that I think is the one for neither, and a pulley that is for viscous & power steering - I know they don't fit properly

I looked for other pulleys and gave up, so I'm probably going to make up some kind of spacer but I haven't measured it up yet


if you measure yours I'll check what I've got (maybe we could just swap - fingers crossed)

[Edited on 17/7/09 by mcerd1]

the dimensions are
new
centre hole 20mm
mounting holes m6
depth 35mm
diameter 110mm

pinto
centre hole 25mm
mounting holes m8
depth 40mm
diameter 110mm




sorry for the poor photos the pinto one is the rusty one.

what size is the pump you've got ?

sorry just reread my original post .....

my problem is the pulley not the pump

sorry for the curve ball!!

I think I understood your problem (I had to read it twice though )

I'm just trying to work out which size of pully you actually need......

i have a water pump you can have it if you want

sorry for the vague posting

i have just finished a 27 hour shift at work!!!!

its the bigger of the 2 i need with the 25mm centre hole.

cheers