would this manifold fit on a 3.5 rv8 block ?

I could then use megasquirt to run it?

Paul

link
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=230357639676&fromMakeTrack=true&ssPageName=VIP:Watchlink:middle:uk


[Edited on 23/7/09 by Paul (Notts)]

Paul,

have a look at Rimmer Bros online catalog for the series II disco.

Looks very similar to me.

The one on ebay should be very easy to fit and run MS.

Sounds like a bargain.

Hi Paul,

I'm pretty certain all RV8 inlet manifolds are interchangeable, if you look at aftermarket ones like the edelbrock or JWR they make no reference to only fitting certain blocks.

Cheers,
Dan

Yes, no problem fitting this to the heads but they are not as good for max power as the old ones, not sure if you will still be able to run a distributor though.

Does look expensive to me.

[Edited on 23/7/09 by mark chandler]

I thinks thats refered to as the thors system They are quite tall IIrc.

Look for a traditional ( 3.9 or above ) RR one, I may have one in the garage surplus to requirements.

Regards

Agriv8

Yep - thats a Thor manifold. For some side by side comparisons, have a look here..
http://spagweb.com/v8mini/gallery/05/01_efi_compare/