Hi all, i now have my zetec engine. i also have a 5speed type 9 gearbox and bellhousing... What do i need to do with the flywheel and clutch (what type?), bearings (what type?), and starter motor(again what type?) and i'm i forgeting anything...???
Thanks

Hi,

I used a combo for my clutch with the pressure plate from the Zetec and the friction plate from a CVH. You need a spigot bearing (Burton Power) and a new release bearing from a Capri (QH no. CCT133) and a CVH starter motor.

With those bits it should go together ok.

Chris

Im running a 1.8 currently and using the zetec friction plate and pressure plate along with the sierra thrust bearing and arm. No problems to date done 6,000 miles you do need the spiggot bearing.

Would this one do?

Link to ebay

That looks like the chap...

what cvh starting motor?

Mine came from a 1.8 cvh from a sierra.

You can use a pinto one but i think some spacers are needed. Not sure of the details on that though......

Chris

...or a DOHC (2.0 Twin Cam) Sierra one

If you use a pinto starter you need
a 14mm spacer between the starter and bell housing.

Andy