Is there anyone out there with a set of Honda Blackbird throttle bodies who could do me a bit of a favour and measure the centre to centre spacing?
I've got a manifold which, acording to a couple of sources on the internet, might match up - but as we all know how reliable the internet can be sometimes it would be useful to have the spacing confirmed before I actualy buy any

I can do it tomorrow if that's any good? Do you just need port spacings?

Cheers
Davie

if you still need things measuring u2u me next week, i'll be in the garage the whole week so should be able to find time for you to measure up.

if fact, if you want and you let me know sharpish, i can lend you a set on Saturday.

Going up to see the parents in Standish Saturday AM, returning Sunday PM. If you collect and return - they're yours for a few hours.

85mm as close as I can measure it...

Top men the lot of you! Mike, that sounds like an offer that's too good to refuse - if you stick them in your car I'll send you a u2u with my phone number

I had to go to the garage in my dressing gown to get that info for you...not that you needed to know that of course

[Edited on 21/8/09 by jeffw]

lol yes a bit too much information perhaps but much appreciated!