Hi all,

I've got the engine (893 blade) out of my car at the moment for a gearbox repair, whilst its out I'd like to fit an oil temp and also an oil pressure gauge. I've had the sump tapped for the oil temp so now I need to sort out the oil pressure.

I've done a search on here and I've decided to plug an extension hose into the oil pressure switch location then have a T piece at the end of the hose for the oil pressure sender and switch.

I've found THIS EXTENSION HOSE and THIS T-PIECE. Can anyone confirm if these parts are what I need for the job?

I'm slightly concerned about the hose and wether it would be any good for hot oil? If not does anyone know where I can get an extension hose from as I searched google + ebay and these come up in their hunderds and not much else.

Many thanks
Mark.

Have a look at LMA as they supplied all my senders, pipes and adaptors.

http://www.lmaperformance.com/Products/products.html

HTH

Mike

As mentioned above LMA do a complete remote T kit , as i fitted one some time ago.

Mike