Board logo

connecting exhaust
02GF74 - 16/9/09 at 11:35 AM

In order to use my R1 can, I need to get e piece of exhasut tubing and connect to existing system.

I have a 90 degree stainless bend that is 50 mm O.D.

I am looking at somehting like this:


10 degree stainless pipe, available in 2 in and 2.25 inch diameter but not sure what size would be best.

The 2 inch would need to be stepped down to fit inside the 90 degree bend and the 2.25 inch I think will be a bit too loose over the 90 degree bend, altough I could weld that up in theory with a sleeve inside.

So what would you recommend?

A1 - 16/9/09 at 11:48 AM

what size is the inlet to the R1 can? Id just do it that size...

chris_smith - 16/9/09 at 11:49 AM

are you after a stepped sleeve? this guy does them on ebay very quick delivery next day virtually any size dia

linky

02GF74 - 16/9/09 at 11:50 AM

quote:
Originally posted by A1
what size is the inlet to the R1 can? Id just do it that size...



way too big - 60 mm. do not want many steps in the system if I can avoid it.


^^^^ pipe-werx - same peeps as my photo - you can read it in the backgorund

I am thinking it would be best to get a 2 inch 10 degree pipe with a 90 degree bend but that would need to be a special - he does both but as separate pieces.

[Edited on 16/9/09 by 02GF74]

Gary 7 - 16/9/09 at 06:32 PM

I purchased a pipe from pipe works and they can reduce or enlarge the ends to various sizes just tell them what your looking for.I found them very helpful.