Board logo

Exhaust fabrication
Toprivetguns - 15/10/09 at 11:05 AM

Hi,

Looking for anyone who can fabricate exhaust tubing here in Herts. From the picture I just need a new centre piece from the manifold to the rear box. The existing section slightly angles out too much.

Cheers

omega0684 - 15/10/09 at 11:12 AM

how about sending a u2u to 907 on the forum, im sure he'll be able to help

blakep82 - 15/10/09 at 11:13 AM

or, if you can weld, slice with a cutting disc, an weld back together

Mr Whippy - 15/10/09 at 11:45 AM

seems like you could have done with 3 inches taken off the header too as the collector looks very far from the side of the car

blakep82 - 15/10/09 at 11:47 AM

hmm, actually, have you tried moving that pipe around at all? i think if you flip it over (so the end currently fitted to the silencer is on the header side) and twist it round it should make a big difference?

Toprivetguns - 15/10/09 at 12:15 PM

quote:
Originally posted by blakep82
hmm, actually, have you tried moving that pipe around at all? i think if you flip it over (so the end currently fitted to the silencer is on the header side) and twist it round it should make a big difference?


Yes I have, however the angle changes again, lol. Also each end is sized different so the system can only fit one way.

This is orignally from Paul fishers ZX10. I know every Mk indy is unique, hence it was cheaper than a new unit assembly and would only need minor tweaking.

[Edited on 15/10/09 by Toprivetguns]