Board logo

LOCOST Laser / Waterjet Cutting - Herts
MakeEverything - 31/12/09 at 11:04 PM

Can anyone cut these in hertfordshire onj the cheap for me please?

Boggle (Bless him) has been reeeealy helpful, and i feel guilty that its always him digging me out of the poo!

Anyone local to Stevenage that can run these out for me please? I need Three of these.......

MakeEverything - 31/12/09 at 11:04 PM

and five of these......

minitici - 1/1/10 at 02:06 PM

Having trouble importing your .dwg files into TURBOCad Pro5 (Mac).
Get construction lines but that is all.
Try exporting as .dxf
Doug.

MakeEverything - 3/1/10 at 03:19 PM

Ok, in DXF....

MakeEverything - 3/1/10 at 03:20 PM

and the other,....

MakeEverything - 3/1/10 at 07:02 PM

And now the T3 Flange.....

MakeEverything - 3/1/10 at 07:03 PM

In DXF.....

minitici - 3/1/10 at 07:16 PM

Hi Richard,
Had a look at the files again (both .dwg & .dxf).
The 2D dimensions and outlines are there - but had an undefined line colour on import to my Turbocad therefore were initially invisible!
Were these items modelled as 3D solids?
Doug.

MakeEverything - 3/1/10 at 09:36 PM

quote:
Originally posted by minitici
Hi Richard,
Had a look at the files again (both .dwg & .dxf).
The 2D dimensions and outlines are there - but had an undefined line colour on import to my Turbocad therefore were initially invisible!
Were these items modelled as 3D solids?
Doug.



errrr, i dont think so. I just measured the parameters from a datum, and put the shapes together.
So, no i dont think they were put together as 3D solids, though the Blue Flame file works to a point.