Need a bellhousing making/modifying.. have some base materials here..

Basically want to mount a Toyota rwd gearbox to a Rover T16 turbo...

Have a slightly modified fwd rover box (stripped) but need a spacer to mount the toyota box.

Any experts can help??

Looking forward to 220bhp

There was an off the shelf item available for the Rover turbo IIRC....think it was to a T9 though

If you can use cad, measure every bolt hole from each other, and the input shaft from all of them and then use intersecting arcs to plot them all. use 5 layers, a pair for the rover flnage (construction and final) and again for the toyota box. Once done you can draw the required flange to clear the clutch, hold the starter and take in all the required mountings. Then get it laser cut at a machine shop.

Didnt Gbs do a flange to go from the rover to mt75 ?

Its a cheap box and will easy take 220bhp

Give R1_pete a u2u before he bins it.