Morning All,

I am currently trying to fit one of AB Performances paddle shift gear selectors, via a pull-push cable, to a ZX12 engine.

Ive been told however that the leaver arm on the gear selector that comes out of the engine is not long enough, and that i need the arm off a ZX14 (guessing that a longer throw is required).

Does anyone either know where i could get one of these from ?. OR, does anyone have a ZX14 motor which they can measure the length of the arm (between piviot points) for me ?

Cheers
Tris

the selector bar on mine is 100mm.
It's got 2 holes cable/rod end for adjustments.
Remember, longer the bar, longer the throw.
Dave