Does anybody have one of these lying around?
Its the little part which the drive shaft bolt goes through
Thanks

Ahah, the ballast weights, added instead of casting the diff body out of iron

What do u mean dude? These are the little plates that are like 50mm long and thers 3 of them at each end of the drive shaft

Throw away and use shakeproof washers if you have ruined one

quote:

---

Originally posted by PuppiesBalls
What do u mean dude? These are the little plates that are like 50mm long and thers 3 of them at each end of the drive shaft

---

i used thse http://www.namrick.co.uk/acatalog/Home_Mixed_Plain__Spring_and_Shakeproof_Washer_43.htmlesw

as above

[Edited on 17/7/10 by plantman]

quote:

---

Originally posted by mark chandler
Throw away and use shakeproof washers if you have ruined one

---

Any body got one?

Nope - I bought a new set of these from ford when I replaced the back end on mine.

not cheap though...

I think i may well have some, i will have a check in the morning before i go to the uxbridge show.