Hi, my stainless 4 branch manifold is angled too far away from the car to fit correctly. Any suggestions on how to bend it to get it to fit where it should?

Have you got the collector on the correct way. Better to post a pic so we can see exactly what is wrong.

My Viento exhaust was the same. The manifold goes down to the 4-1 and then the outlet to go to the link pipe, then silencer. I ended up having to have new link pipes made so the angles were correct (with a slight dog-leg in them). My problem was they were too tight to the car and fouled but the angle would have made the exhausts really wide (if they hadn't fouled!)

Mark

[Edited on 18/7/10 by Paradoxia0]