Board logo

Help with resetup Pinto Vernier pulley
black.viper - 26/7/10 at 07:58 AM

Hi mates, I would like ask for help with this vernier pulley:



I tried resetup it but without success .-( I couldnīt turn with this although I loosen all screw!!! I dont know how much I could use the power - I tried help a littel wiht screw driver like crowbar... but wihout effect - belt is down when I manipulated with this...

Questions:

1. Are you have belt down with resetup it?
2. How much power you must use for resetup it?
3. Any idea what I could do with it?

Thank you very much for any answer.

Regards,

Petr

mookaloid - 26/7/10 at 09:00 AM

burton power cam fitting instructions page

Edited to add: you do realise that you need to turn the camshaft for fine tuning once the pulleys etc are in the correct place?

[Edited on 26/7/10 by mookaloid]

omega0684 - 26/7/10 at 10:45 AM

^^^^ tells you everything you need to know!

black.viper - 26/7/10 at 03:45 PM

quote:
Originally posted by mookaloid
burton power cam fitting instructions page

Edited to add: you do realise that you need to turn the camshaft for fine tuning once the pulleys etc are in the correct place?

[Edited on 26/7/10 by mookaloid]



Ok thanks... sorry for my english but the problem is elsewhere...

Engine is running good. Timing is due camshaft (FR33) - but I have problem that I could turn with pulley parts among themselves with (blue parts agains black) ...
I released all bolts but withou effect ... I try use row power but without effect... I dont know how much rgross I could use...or if is there some trick .-)

Thank you for patient .-) with me.

mcerd1 - 26/7/10 at 04:06 PM

will it come apart if you take the bolts out completly ?

black.viper - 26/7/10 at 08:35 PM

quote:
Originally posted by mcerd1
will it come apart if you take the bolts out completly ?


No, I did it ...but not happened... all bolts were out, I tired turn parts among togeather but withou success .-(