Board logo

identify the exhaust....
nib1980 - 5/3/11 at 06:19 PM

Hi All,

I got a manifold that fits a treat to my car, but i have no idea what exhaust can its maent to fit.

can any one tell me?

do i need anything special to make it fit? gaskets rings etc?

Is it a ZX9R can fittment?

many thanks

Neil


[img]
Untitled by nb_photos, on Flickr[/img]

austin man - 5/3/11 at 06:36 PM

cant yo remove the flange and get another box to fit ? off topic slightly where did you get the roll cage from?

Andy W - 5/3/11 at 06:40 PM

Hi

Could well be a zx9 exhaust they mount with 3 studs, I have an alloy can for a zx9 in my garage, I'll measure the holes centres in the morning for you

Andy

nib1980 - 5/3/11 at 06:48 PM

quote:
Originally posted by Andy W
Hi

Could well be a zx9 exhaust they mount with 3 studs, I have an alloy can for a zx9 in my garage, I'll measure the holes centres in the morning for you

Andy


thanks Andy.

Is it for sale aswell?

nib1980 - 5/3/11 at 06:49 PM

quote:
Originally posted by austin man
cant yo remove the flange and get another box to fit ? off topic slightly where did you get the roll cage from?


Stuart Taylor, now aries motorsport i believe

mark chandler - 5/3/11 at 06:53 PM

zx9 for me as well, although the pipe should not stick in the can like that, I would expect it top be cut flush after the flange.

Gut the can and extend the internals with perforated tube then the extra pipe makes a bit more sense.


Regards Mark

prawnabie - 5/3/11 at 07:15 PM

The ZX.. exhausts do extend behind the flange into the exhaust can, but you usually have to cut them down to fit an aftermarket can. GSXR's also have a similar set up although the are differences between the pcd on the flange between pretty much all of the engine sizes on both makes.

nib1980 - 5/3/11 at 07:18 PM

anyonw know a site that will have the flange dimension for me to look up?

Andy W - 6/3/11 at 04:51 PM

Hi

Just checked and the holes 45mm PCD
I have an alloy can if you are after one


Andy

nib1980 - 6/3/11 at 05:01 PM

quote:
Originally posted by Andy W
Hi

Just checked and the holes 45mm PCD
I have an alloy can if you are after one


Andy


thanks andy, i'll have a measure and let you know ASAP

nib1980 - 6/3/11 at 05:16 PM

quote:
Originally posted by Andy W
Hi

Just checked and the holes 45mm PCD
I have an alloy can if you are after one


Andy


45mm PCD seems very small, is that the radius?

welderman - 6/3/11 at 05:45 PM

Standard ally fireblade can has 3 holes too. Could fit that

nib1980 - 6/3/11 at 05:48 PM

quote:
Originally posted by welderman
Standard ally fireblade can has 3 holes too. Could fit that


do you know the PCD of them?

welderman - 6/3/11 at 08:55 PM

I might have one I can check tomorrow

nib1980 - 6/3/11 at 09:10 PM

quote:
Originally posted by welderman
I might have one I can check tomorrow


if you could that'd be great thanks