hi all, just wondering does anybody know where the air correction jets are on these carbs???

trying to set up the zx9c carbs for a mid tuned pinto, any ideas on starting settings?

cheers

stu

The air screws are under the carbs up some small tubes on zx9r /E carbs so i think they will be in the same place on your carbs
Or do you mean the ones you block off some times depending on the engine set up ?

yes jacko the ones you block off

stu

In this photo its the little brass jet holes at the top of the 2 brass holes you see the ones that you block are inline with the main needles

Are you sure yours need blocking ? not all setup need these blocked

cheers for the picture i will try and compare them to mine.

i do not know if i need to block them off, just that i have read in a lot of places you need to block them of.

cheers

stu