Hi all,

After getting the engine in as some of you have seen my earlier 'Wedding post' I need to ask a few questions please.

The gearbox mount (from Caterham) seems to be tipping the engine slighly forwards.

This means the prop shaft is at a slight incline - gearbox tail is little bit higher than diff flange.

So is this the norm, have I got the wrong gearbox mount?

Will it be a problem?

Thanks in advance.

I like mine level Can you not space the mount to get it level ?

it should be fine, as long as the gearbox output and diff flange are parallel, then its all good.
look at rigid body truck, their props run at quite an angle!

I had to put12mm blocks between the chassis mounts and the gearbox mount to lower the back end of the box
Jacko