Board logo

Cross flow nuts & bolts
Nickctp - 16/9/12 at 09:34 PM

Bit of a strange one but does any one know where or if you can buy a complete set of bolts for a cross flow? Bolts to hold fuel pump, dizzy etc etc. Or if not where is the best place to get a selection of bolts for one??

Cheers

Nick

rusty nuts - 16/9/12 at 09:52 PM

A lot of them are 1/4 " and 5/16" U.N.F

wonderfulweasel - 17/9/12 at 01:00 AM

There's a seller or two on eBay that does them. They tend to sell them in smaller kits, such as a front cover set, or a water pump set.

I got some off someone with a username that was something like jims_grandpa, and had no problems with the ones I used.

hypersonic - 17/9/12 at 05:53 AM

I also got mine off ebay. They do a full set which are plated too so look good.

Nickctp - 17/9/12 at 07:15 AM

quote:
Originally posted by hypersonic
I also got mine off ebay. They do a full set which are plated too so look good.


Dont suppose you can remember the seller? I can not find a single kit - unless I am typing the wrong thing!

Cheers

Nickctp - 17/9/12 at 07:16 AM

quote:
Originally posted by wonderfulweasel
There's a seller or two on eBay that does them. They tend to sell them in smaller kits, such as a front cover set, or a water pump set.

I got some off someone with a username that was something like jims_grandpa, and had no problems with the ones I used.


Cant find any It does not even look like Burtons sell any kits!!

David Jenkins - 17/9/12 at 07:20 AM

The important ones (flywheel bolts, cylinder head bolts, etc) can still be found at Burtons.

The general non-critical ones are UNC and UNF, which can be bought from places like Namrick.

Nickctp - 17/9/12 at 07:22 AM

Ahhhhhh haaaaa!!! After much searching on ebay I fanally found a couple of complete kits - A bit pricy at £21 a kit but - hopefully i'll only need them once!

Cheers all

N