Has anyone got the specs for tappet and points gap on a standard pinto engine please. Cheers Floaty

I can do you a scan of the haynes data pages later tonight if you don't get an answer by then...

If you mean spark plug gap - 0.8mm
I think all distributors were inductive so no contact breaker points.
Valves - inlet : 0.2 +- 0.03 mm
- exhaust: 0.25 +- 0.03 mm

Ford/Fomoco/Autolite distributer (one with black cap) points 0.023" to 0.027" -- always set at wide end of range and recheck after 15 minutes running as gap tends to close up.

Bosch distributer (red/brown cap) 0.015"

Points distributors need setting up between 48 to 52 degrees dwell angle