Hi Everyone.

I need a spacer making on a lathe if anyone can oblige, I am of course more than willing to pay! It is for my cooling system so could do with being aluminium if possible.

Basically it needs to be the same as the top left image on this link.

Spac er

Just the 3.13" ish od tube with the 1.90" hole in the middle and a 0.04" deep x 0.18" wide step on one side will do for the stat to sit in - I can do the rest.

Thanks in advance,
Shaun.

A day too late- started. 8 weeks holiday yersterday afternoon but in the morning our expert turner was looking for things to do!
Atb mike

Probably could do it during dinner times.
however if someone else would rather, here's a drawing in proper metric
https://www.mediafire.com/?soo39za72ur0vjs <full resolution pdf



[Edited on 5/7/14 by 43655]

Ahhh thanks for finding that!

I only need the step cutting on 1 side and I can drill the holes myself!

Thanks again..

hah no i drew it
the 1.02mm deep bored bit?

Wow wish I could do things like that!

Yes I only need that on 1 side if possible

Thanks