Hello

can anyone do an initial set up on a OMEX600?

I think my flywheel may not be lined up where the ECU thinks it is

In Retford area and happy to pay for help from anyone who knows their stuff

Even a remote session through teamviewer etc onto my laptop would help

What engine is it? Normally the flywheel only bolts on in one position...

ST170 with static timing

See my recent plea for help :- )

http://www.locostbuilders.co.uk/forum/9/viewthread.php?tid=210102

I'm not familiar with the omex software, has it got a trigger offset setting?

not by that name. it has a mX tooth setting on the crank sensor set up, which is set to 34. when I crank the engine it shows "stat sync'd" (not sure what that means but it's good apparantly", but when I change it to any other tooth the 'stat syn'd" = no

I suggest you ring Omex on Monday, they will have a standard map for an ST170 and will talk you through it.

Omex have been helpful and sent me a ST170 map, but still not running

Speak to them again and ask them who they recommend to map the car local to you and the take it there. They can get it running and map it for you.

Will do - thanks