What are the limits on this?

I reckon I have around 0.75mm (at the furthest point from the bearing) - bearings gone or worse?

there will be some play if the gearbox is seperated from the engine - once the two are connected the spigot bearing in the end of the crank will support the input shaft.

Ned.

Is my 'wobble' normal then?

Edit - My gearbox is seperate.

[Edited on 19/3/06 by Mansfield]

I have a gearbox from BGH Geartech that has just had first gear changed. I have about the same movement and they never said there was a problem. They checked everything over when they did the gear change.

Dave B

Thanks Ned & Dave, much happier now.

I love this website.