Lookoing for ideas to make a bump stop for the acceleerator pedal; when it is fully depressed , the carbs limit its travel - not good.)

Don't know the best way but either could make a bracket at the top of the pedal to limit it or a bolt in the foot well.

Ideas?

L bracket riveted through floor with a hole in the L put a nut and bolt through then you can adjust

chris

Bolt in the footwell would probably allow for easier fine adjusrment as it would be further away from the pedal pivot.

Mick

Threaded run with an L piece so's you don't have to mount on the radius steel.

Like this here on 1st December.

Steve