Evening all..

I have managed to convert my sierra pedal box and type 9 gearbox to hydraulic clutch using a landrover master cylinder and a wilwood pull slave cylinder.

The pushrod on the lanny master cylinder is about an inch too short and I need to join it to a piece of threaded rod.. (at the moment it is locked together using 3 nuts but this is bound to vibrate loose!)

This is where the problems start as I cant seem to find any threaded rod joiners with a 5/16" UNF thread.


So, anyone know where I can get a joiner with a 5/16 UNF internal thread (plenty of metric ones available) or is there anyone out there who could make one up for me for some beer tokens!

Where are you? If you're near leicester drop in and I'll knock one up for you

Thanks for your offer, I live in Dunstable, nowhere near Leicester!

I dont mind sending you some dosh to cover your cost's and postage etc though....

Ta

Kevin

How long does it need to be? I'll try and get one knocked up tomorrow night.

about an inch long should do it..

Thanks alot

will make it then u2u to get address to post to.

cheers

Nat