The fuel inlet pipe on my 32/36 is loose. its so loose I can pull it out. Any advise as to how to fix it in place or is the carn goosed?

Cheers

Richyo

Could you tap the hole and use a threaded fitting of some kind? Maybe a Goodridge threaded hose fitting - then make up a bit of fuel pipe with the corresponding fitting to connect to it?

Alternatively some fuel/oil resistant instant gasket/sealer may work.

HTH
Nick

This used to happen a lot on Scimitars - the solution was to drill a hole in the casting and 'pin' the brass pipe in place - presumably with some fuel resistant sealer to stop it leaking.

On my Scimitar the pipe came loose when I was touring Scotland - I was very lucky to smell the leaking petrol before the pipe came right out and squirted petrol all over the top of the V6

Cheers

Mark

Had just the same happen on the sierra road rally car (pinto with 38dgas carb)

Loctited it in on that

Thanks Guys