I am in need of the thread size of the temp sender on a pinto block.

anyone know ?

Just done a painfull search on the site and i am no better off,its either 1/4 NPT or 1/8 NPT.

I wish i had writen the size down when i asked the queston a couple or thre years back

Bob,

I think that its M10 fine.

Cheers,

Colin

Thanks colin, i'm pretty sure its not M10 fine.

I remember being told it was NPT though.

1/8 NPT Bob.......

Fozzie

DLT and I would like to publicly apologize to Bob for our abysmal Sunday info service....
Tee-hee

quote:

---

Originally posted by bob
Thanks colin, i'm pretty sure its not M10 fine.

I remember being told it was NPT though.

---

No worries colin

I should have really put the thread size in my notes when building, the reason i'm asking the question this time though is not pinto related. I want to keep the VDO temp gauge and sender i used with the pinto and plumb it into the zetec water works,hence needing to know the thread for the inline adaptor.

I am now sure it is 1/8 NPT big thanks to conrodkid (again) and fozzie and DLT for making an effort