Hi all - can someone please give me the measurements from the rear flange that bolts to the diff to the centre bearing mounting bolts? Also can you tell me the width of the plate that mounts the centre bearing. This is so I can weld a plate in the chassis in the correct place for bike engine conversion. Thanks Jacko ps this is to suit sierra diff in mk chassis

[Edited on 25/9/06 by jacko]

Graham, have you seen the light at long last, or are you modifying someone elses Indy ready for the bike engine conversion

Phil

Apologies for not responding with an answer to your question

Hi Phil no it's not mine [ up the pinto power ] it's Tim and Tom windmills car

Graham

Thought it might be. Oh well never mind, there is still hope for you yet..........

Phil

ONE DAY

!!!I have seen the light!!!!

Hi - don't you builders have a prop you can measure for me thanks
Jacko

No one fitting a prop then

I have a Sierra prop if you just want the measurement from the rear face to the bolt centres I'll measure it tomorrow. If you are mounting the centre bearing with M12s I would go with something like 40x3mm for the plate

THankyou Peteff thats what i need measurements Graham