As the title says, i am having trouble figuring out what clutch to use. The flywheel is from raceline. I believe some of the 8.5" clutches for the 4cyl mustangs will work, but not sure. Anyone have direct experience or opinions.

TIA. Cheers, -sm

if its a T5 box , a cossie clutch plate should work , if its the correct diameter .

find out diameter , and number of splines on the input shaft and youll be in a much better position , theres loads of aftermarket for T5 boxes .

IIRC theres a guy on here done a 2.3 duratec before, he may know...Cairb i think

The input shaft is standard t5: 1 1/16" x 10spline.

AP would have one listed , im sure any cossie clutch disc would work , as long as the diammeter isnt too big , im assuming a cover from the original duratec would work ?

if the flywheel is from raceline , contact them to see what its been drilled for .