Does anyone know if the slave cylinder that burton sells (Part no APC5)is the same as the Saab 900 (79-93 part no 4776308)? Or if the Saab slave cylinder (4776308) fits Burtons mounting bracket for type 9 (Part no APC6B)

I can easily find a Saab slave cylinder here i Sweden but i need some sort of mounting bracket aswell.

[Edited on 1/11/06 by Micael]

[Edited on 1/11/06 by Micael]

[Edited on 1/11/06 by Micael]

May be of assistance.
The AP release bearing uses the same hole spacing as the saab one.

AP slave Tech Drawing

I belive that ford also do a concentic relaease bearing but i am unsure if this uses the same bolt patern as the Saab.

looking at the pictures though it look like the bolt patern is very similar to the Saab setup.

PS I am using the AP one I hoped to use the Saab one but it would not fit over the input splines of nmy Getrag Box.

regards

Agriv8