Does anybody out there know if the inlet port spacings on the ZX12R are the same as the ZZR1100 ???
Thanks Davie

I doubt it, think the ZX12 is a completely different lump to the ZZR1100 (which is almost identical to the old ZX10 & ZX9R).
I can measure the port spacing on the ZZR1100 if that helps? .....

Is this of any use? It's a ZX12R Engine.

Phil



[img][/img]

ZZR1100's are about 40mm dia and spaced 75mm - 85mm - 75mm centres.

Mike

Thanks all, looks like a definitive no then.

Regards Davie

ZZR 1100 T/B are from memory 26mm? and spacing can be altered fairly easily with a little thought